Recent content by markT

This listing has been renewed

My AA S 410 and AA S200 both are “bolt” cocking. I just use my thumb on the opposite side from the handle and use my fingers as close to the body of the bolt and they both cock nicely.

Appreciate that. I’ve been around compressed air most of my career and fully understand and respect the amount of energy we are dealing with. Yes, they are expensive and I’m very happy I spent the extra $$$$ for something I don’t have to work on. At least I hope not to. 😊 I was so excited when I...

Thanks to all you guys about everything! I’ve had surgery (rotator cuff) and my mobility at the moment is very limited. With closer inspection, I got down and looked at sight glass and yes there is a diagram. ( again dumb as$) upon my first operation the compressor walked and learned the rubber...

What’s your application? Squirrels / paper? Distance?

Did the OP purchase a M4 and where did you buy?

Question about oil level: My new W31 came with oil above the "red dot" in the sight glass. The level in at the very top of the sight glass. I sent Alkin a meassage: as follows: "Hello, received my new W31 last week and the oil level is above the “red” dot. Should I drain it to get is level with...

@Scotty1: thank you sir! I just wired the yellow /green to ground. And discovered the yellow green wire had a ”ground “ label on it. Yep I’m stupid. My compressor sits against a wall where my sub panel is on the other side, so I just drilled a hole thru drywall and connected directly into 30 amp...

Cheapest: If you are open to having a member here or from somewhere, probably happy to shoot your GH’s.

OP:.. “What kind of adaptor would i need to transition into that they of tank.? Any and all information would be great.” :unsure:

Question about wiring: the wire from the “control box” has three wires: blue, brown and yellow with green stripe. Blue and brown connected directly to double pole 30 amp breaker in panel. The yellow wire? Does it connect to the white wire (in panel) (neutral)or direct to earth ground? I just...

If you can bait them, then set up a feeder at known distance ( ~35yds) and hammer with budget pcp.

Fit, feel, function. Trigger( very big) sound of hammer striking valve ( some YT videos are annoying) and exhaust gas ( extremely important) Then there’s that consistency thing. Some say accuracy..

This listing has been renewed

Marketing!! FX=Genius