Recent content by marflow 777

i have had my P17 opened up and had no problems but when i went to open my HW40 the cover was very hard to move and just stopped like this post that Gary made i to made a longer trigger adjustment screw and working with the trigger out was easier the HW40 has many springs and pins and you can...

the problem is Diana as a brand, is moving away from manufacturing to, just branding and selling BlueLine show the 460 and 48 but Diana DE does not it is the end of the brand as we knew it unless something changes

i would think that the stem seal is not an Oring but flat sheet goods and the material would need to be urethane i have been looking at the parts diagram in the owners manual the stem is like most of the stems that Benjamin used in all these CO2 pistols the stem is also like a S&W 78-79g the...

they have an email, they have a phone number have you used either should we assume it is this place now i would have contacted them long ago and after a while just cancelled the order

okay so, if the rifle were sold in any numbers say in the 1960's i would have thought the Blue Book would have them in it my point about Europe was someone bought them back, say a military man or woman it really doesn't matter most of the Slavia's are very similar till the 634 came along

i saw this post earlier and the first thing i did was look in the Blue Book and neither of the rifle was listed and then i when to Waffencenter in Germany and only one was listed and that makes me wonder, were these bought back from Europe at some point and never imported

i have a amend my last post i had an idea of how the seals could fit without the stem being removed that was take and remove the lip on the seal cup and then reduce the barb on the stem so, in the drill the stem went, chucked up on the spring side and used an exacto knife to scrap the lip...

the parts diagram at JG air guns doesn't show that piece to be threaded even though it looks that way oh, i can see the damage but the set screw is holding it together with it set in the dimple would i put something on the set screw hell yes would i try to shim the stem with something maybe but...

so, there are few 603's that come up for sale in the states besides what Carel sells out of Europe some i have seen reach the Blue Book price and even exceed it your rifle even though it needs rebuilding to bring it to 95% would be in the 1500.00 range maybe a little less now their buyers and...

i have said many times this hobby is easy till it is not i have done my 3 --S&W 78-79's in the past and got the material to replace the valve stem face used leather punches to make them use a vise and a wood block to push the stem out of the Brass seal holder and reassembled so i told Mark to...

yes i said 2mm for the first hole and 2.5mm for the final hole For tapping a 3mm screw thread, the recommended drill bit size is 2.5mm. This size ensures sufficient material for the threads to be cut properly without being too tight or too loose.

if i were you i would try to take the front sight mount off first i remember trying on a dead 48 i have and gave up now most posts will say you can just drill out any muzzle brake to 15mm and to that i say HORSE FEATHERS you would need a drill press a way to hold it 90 degrees to the table and...

so, someone tell me if the pin was outside the breech block will it hit the stock...

so, all that is a metric round standoff now finding one the right size and the right material could be the challenge

it is the problem of want over need and as many of us know WANT will always win but the question is at what point is too many too many is it 10 or 20 or 50 or 100 at 10 i would say you have given up and at 100 i would say what are you getting next the guns are not a HAM SANDWICH, once...