marflow 777's latest activity

i have had my P17 opened up and had no problems but when i went to open my HW40 the cover was very hard to move and just stopped like...

the problem is Diana as a brand, is moving away from manufacturing to, just branding and selling BlueLine show the 460 and 48 but Diana...

i would think that the stem seal is not an Oring but flat sheet goods and the material would need to be urethane i have been looking at...

they have an email, they have a phone number have you used either should we assume it is this place now i would have contacted them...

okay so, if the rifle were sold in any numbers say in the 1960's i would have thought the Blue Book would have them in it my point...

i saw this post earlier and the first thing i did was look in the Blue Book and neither of the rifle was listed and then i when to...

i have a amend my last post i had an idea of how the seals could fit without the stem being removed that was take and remove the lip on...

the parts diagram at JG air guns doesn't show that piece to be threaded even though it looks that way oh, i can see the damage but the...

so, there are few 603's that come up for sale in the states besides what Carel sells out of Europe some i have seen reach the Blue Book...

i have said many times this hobby is easy till it is not i have done my 3 --S&W 78-79's in the past and got the material to replace the...

yes i said 2mm for the first hole and 2.5mm for the final hole For tapping a 3mm screw thread, the recommended drill bit size is...

if i were you i would try to take the front sight mount off first i remember trying on a dead 48 i have and gave up now most posts will...

so, someone tell me if the pin was outside the breech block will it hit the stock...

so, all that is a metric round standoff now finding one the right size and the right material could be the challenge

it is the problem of want over need and as many of us know WANT will always win but the question is at what point is too many too many...