Recent content by makarov2088

Well, it's my problem, I'm not very professional. Sorry for the delay everyone's time. ^_^

I adjusted the stop screw and it has been improved. The inflation to 200 bar, the live ammunition test, and the empty magazine test are all normal. After the empty magazine is launched, the air will not leak if the trigger is not released. But when the pressure drops below 60 bar, after the...

Your expression is very detailed and I can fully understand it. Thank you very much for your reply. Next, I will try to adjust the stop pin, and the effect will be shared.

Hello, thank you for your reply. I don’t seem to receive the email. I only received a reply from a Polish distributor and a reply from a Polish friend, but none of them mentioned the stop pin issue. I will try your method now, adjust the stop pin, the ultimate goal is to make the screw on the...

Just shooting without a lead bullet will consume all the gas at once, so are you? we are the same?

I conducted a detailed test again, because I did not load lead bullets from the beginning to the end. Just now I installed the bullet test and everything is normal. It consumes about 7 bar each time, and there is no need to release the trigger after shooting. The gas will not Leak, the valve...

You are right. It is not the problem with the red rubber ring. I am using a large one. It still consumes 5 MPa at a time. I am at a loss.

I just asked the seller. The seller told me that I had a red rubber ring and forgot to send it to me. There are two specifications of red rubber ring in the original box. They have different inner diameters. I didn't give me a small one, only 4 large ones. No., so I used a large one. The seller...

Hello everyone I just got L2. I encountered an unsolvable problem. My L2 is 6.35 (250mm), there are two nozzles, one is 0.2, the other is unmarked, it seems that both holes are the same size. The key question is, when I inflate to 15 MPa, the excitation consumes 5 MPa at a time, and there is a...