M Volle's latest activity

I've posted previously about the o-rings in the Avenge-X I was quite frustrated with mine at first and had leaks at several locations...

This site is a great resource for choosing a compressor - I've got several and stories to go with most of them - price isn't a good...

I have thousands of rounds through my 25 cal Avenge-X at this point - had very frustrating start - didn't hold pressure well, didn't...

I used this in my GXCS4, recommended somewhere

I have two compressors that use a closed circulating system with a radiator - although my comment could apply to an open system using a...

The o-rings in the regulator of the Avenge-X seem to take a beating - I switched to only using pure silicone oil rather than silicone...

I bought the Donny FL Yokozuna in .30 cal at their recommendation - expensive and a bit heavy but has been very quiet even pushing 70 FP...

I had some early leaks and then an odd failure - at about 3500-3800 lbs while filling, the burst disk on the gun blew out - this seemed...

You need a caliper to measure the o-rings or compare the old one with the new ones - In my gun there were a number of o-rings that were...

Regarding durometer, a harder elastomer better resists the extrusion forces of higher pressure. Generally speaking, 70 durometer is...

I haven't found a source of this exact size -

that IS the problem - they are all black in the package but two different shore hardness values.... the harder shore 90 rings are all in...

My gun now falls into the "one-off" category - so not completely repeatable. When it was stock, I was maxing out around 870 as well...

Two different steps here - removing the barrel is super simple - there are two recessed set screws in the scope rail on top - loosen...

The Silencer is screwed into the front of the Shroud. The Should will unscrew from the barrel. To remove the barrel there are several...