Recent content by libertybellcdr

IN

We may need to create it. I’m will to help out. We need people to add stores to this thread and I will start a map. If you have a store near you, add a reply with the name and location.

IN

Here's an update for anyone following or looking to learn: I removed my regular and the valve was not correctly firing. I would describe it as "seizing". Once the tank pressure dropped below 2100, it would shoot completely normal. So, I put the regular back in with it set to approx 2000 psi...

I'm in the Huffman/Dayton area. Is anyone participating in shoots or competitions?

Without writing a huge paragraph, I see what you’re saying. I suppose my response is “according to their YT video, they recommend only using 1 of the 2 springs with this valve (of the TSS). I still have the spring backed off enough to give it no ‘hammer bounce’. The video says that “because it...

I use the JS delrin hammer. I couldn’t tell you what my reg is set at. I’m concerned the valve is not working properly so before I just assume that’s the case, thought I’d see if anyone else has experienced the same issue.

This is good info. I have the TSS too. I have played with multiple spring combinations. It is truly all over the place. I’ve put about 100 shots through it. Wasn’t sure if I was wasting my time.

Thanks for taking time to share!

Hi all, I have a gen 2 marauder. Lots of good mods. Lots of tuning. Several Jefferson state parts that I am happy with. My factory air valve broke. Decided to take a chance on the JS air valve. Installed it and I am having issues with my fps ranging from 550-950. It’s all over the place. I...

Haha. This made me laugh. Thanks

I want a new scope for my marauder. I have it narrowed down between the two in the picture. Obviously one costs more, but is it worth the price increase? Thanks for your feedback.

Has anyone created or shared CAD/STL/etc files for 3D printing their own parts to make the AR conversion?

Can we get a copy of that PM?

Hello, I wanted to re-open this to see if anyone has printed the monocore baffle. Any success? Noticeable difference? thoughts?