Recent content by LayeredOgre

I use superglue on the breech oring. Just a tiny little dot on 2-3 spots with equal spacing between them will be fine. It does make an already tricky job even worse since you don’t want to smear the glue around, but it’s held up great.

Depending on the size of the buddy tank, that sounds like great shot count to me. 3200psi is probably around the reg set point from the factory. Just a guess I don’t own one, but looking into it…! Try shooting from 7000psi and no buddy tank, and note the gun’s reg and tank pressures to see...

I’d be super interested in your thoughts and experiences on it, can you share some info on how many shots the 7000psi fill really provides? It’s my understanding that past a certain point compressing air to higher pressures hits diminishing returns, but still I’d imagine higher pressures in...

Thanks to all for the advice! I need to give a huge shoutout to subscriber who set me up with his STL files and print specs. It might be a bit until I’m able to try my luck at printing them but will certainly share the results here.

I might have seen these on here! I would love to get in touch with him for that design.

Well you’d think that! When I’m not moving the trigger it actually still does make noise from my jaw hitting the ground after seeing the groups and chrony strings. Seriously the only thing I don’t like is the noise at its current tune which is inevitable I suppose.

Hey all, I’m looking for some mod recommendations for the Huben GK1. I’ve got mine tuned for 1 mag, ~45 fpe and the buck rail mod I’m using currently isn’t really up to the job at this power level. Width is an issue here to not block line of sight, length not an issue at all. The combo of short...

I use PLA for everything, not an expert by any means. I can attest to using UV coating like others have already mentioned, works great on anything going outside. It might be worth to play around with infill type settings to see how that affects your strength.

Great little gun, but I recently got a GK1 off of here and don’t have much use for it anymore. Shoots dimes with cphps at 25yds, that was good enough for me so I never tried out anything else. Reg works great and zero leaks. The only problem with it is the crappy factory mag which will jam every...

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

I did end up finding a data sheet for the power supply, can’t remember where.

This came with a 1.5L tank I bought recently, I only wanted the tank. New, never attached or filled it. $50 shipped PayPal, Venmo, or Zelle.