Recent content by krisvh

It doesn't BANG anymore ,just the pling on my iron pellet funnel.

You can use whatever washer fits , found these with 22mm width and sand them until fit 21,7mm. With belt sander , put drill in hole and let it roll on belt sander.

I dont know why Hatsan made the QE like this. They made silencers before. You dont need a additional silencer, only some adjustments. Open barrel front , take out the 2 mesh tubes , cut mesh tubes in half and sand the ends. Look for washers 22mm wide , i used washers tar inside for rooftops...

I'm gonna try and change the high pressure piston seals. And again check these valve plates (found better pictures of them)

Hi, I finaly found time to do a service for my Yong Heng compressor. Cleaned everything ,replaced where needed o-rings and reassembled everything. I allready openen it again to see if these little valve plates were in correct position. My compressor only goes to 1500psi. I put a stop in HP...

Hi, I finaly found time to do a service for my Yong Heng compressor. Cleaned everything ,replaced where needed o-rings and reassembled everything. I allready openen it again to see if these little valve plates were in correct position. My compressor only goes to 1500psi. I put a stop in HP...