Recent content by Kopfjaeger

I ordered two sets of these last night. Figured for about $20.00 total with shipping and all...take a chance...

be4meliz, You are on the right track….tap or push it through with something flat, a wood dowel would work fine. The valve plate should move with the plug, it is pretty much flat against the plug so not much chance of damaging it. I have yet to replace the high pressure seals. But I have...

I purchased an AV 4500 psi compressor from Air Gun Depot on 11/18/17. After two years of flawless performance, the armature/drive shaft failed: I put a call into Air Gun Depot over a week ago and have yet to hear back from them.... I posted about my situation in another thread and forum...

Morning Jimmy, Thank you for the Email address, I will definitely contact Jordan. It really sucks....I checked PA and the armature isn't due in until sometime in February. Hoping AV will have one. As far as learning about the compressor, I have a background in heavy equipment/machinery...

Jimmy- Thanks for the links to the parts, greatly appreciated!! I was very surprised to find out that I am not alone in this failure of the shaft. All the more reason in my mind, for Air Venturi to step up to the plate and take care of the customers who have had the shaft completely break in...

I'm not expecting a "free" replacement. I am hoping they will work with me to get it repaired at a reasonable cost or perhaps a new compressor at a discounted price. As I stated, I know it's out of warranty.....this type of failure for a solid steel 1" shaft that drives two small...

Hello All, I purchased an Air Venturi Compressor from Air Gun Depot back in November of 2017. The only issue I've had with it was about a month ago. Had some buildup on the valve plates that didn't allow it to make pressure, I was able to clean them and restored normal function. Aside from...

Well that is normal...when the grub screw is tightened, it is tightened against the threads of the hammer spring screw. This will flatten the threads slightly on the hammer spring adjusting screw and it will not turn easily...it will turn with some effort...you may have to turn back and forth...

There is probably a lock/grub screw tightened against the hammer adjustment screw. You will have to remove the two small allen head screws that hold the hammer adjustment screw assembly and remove it from the gun. Loosen the grub screw, make your adjustment and tighten the grub screw...

I've seen some pics of a catastrophic failure of the high pressure piston rod coming loose on a Yong Heng...the head and the rod look to be the same as the Air Venturi?!?!?

I seemed to have fixed it!! I cleaned up the two high pressure valve plates by scraping off any build up and then shined them up with scotch bright pad. Replaced the O-rings for the valve plate assembly in the high pressure head. Put it all back together and filled my 97 cu ft tank from 3300...

My Air Venturi compressor all of a sudden won't build pressure. It worked fine last weekend, now it won't go past 500psi. I've had it for almost three years with absolutely ZERO problems!! It runs just as smooth as the day I bought it....no noises like something broke...no air leaking...

choked

Hello, I have recently acquired a Brocock Sniper HP in .22 and it has the LW Poly barrel....anyone have any success with Nielsen .22 slugs out of these barrels? TIA, Rick

Is your Sniper the Magnum? If so, it does not come with the slingshot hammer. I purchased the .22 cal Sniper Magnum about a month ago and was messing with the hammer spring tension and seen that it did not have the Slingshot Hammer. I called AOA inquiring why and the tech said the magnums do...