Recent content by Kime

double post

double post

Hi Chuck, I wonder where did you get the idea to install X barrel to Streamline? 😉 I noted that there is a lot of variation between liners. Some of them get dirty (lead) really fast and accuracy is poor after just a few shots. I have four A liners and only one is perfect without any...

Thank you all, Shooting PCP gun emphty is not good idea because then there is high possibility that you will damage valve pin when pressure is low. Loosening pressure gauge at the end of the tube can be ok, but according to my understanding it need to be done really slowly. There is...

I just change Crown STX barrel to my .25 Streamline and next need to change the regulator to Huma. Now I'm wondering how to release all air pressure from the gun? There is no pressure release screw like in Wildcat. What is the best way to do it?

Rodeo: I'll check the brand when I return holiday from Greece ;)

Thanks, reg gauge is the same FX gauge than front of the gun. I get couple from local FX dealer. I found rear support bag from some small gun shop. It is filled with heavy airsoft BB's. Just perfect ?

Huma reg o-rings are BS119. FX pressure gauge can be even 20bar off. Most probaply huma tester is closer to reality.

Nice groups indeed ! My shooting with WC MK II, King 1,645g@285ms // 25,39gr@935fps

My Wildcat MK II is 0.25 but I have noted that well polished ST-X barrel like to shoot with higher muzzle velocity with a really good accuracy. Now I have set the Huma regulator to 125bar and with correct hammer spring adjustment I get approx. 285ms ~ 935fps with JSB King 1,645g ~25,39 grain...

Hi Jim81, you have exactly same issue than my previous MK I Wildcat had and it is really easy to fix. You need to polish short ST section at the end of the barrel. It is only approx. 5cm ~ 2inch long. Use JB bore finishing compound (or some similar polishing compound) and short cleaning rod...

mtm100: You need to get the spacer ring from Huma. It is longer than the OEM My wildcat is shooting 25,4gr King's 925-928fps with Huma MP regulator set to 125bar. I used Huma regulator tester to check the pressure. Scale on the regulator was quite a lot off. It now reads approx. 133bar but with...