Recent content by kenc295

411.77

1166.12

1177.88

644.55

441.88

19.77

Yep, it was well worth the time and effort to change out all the seals. The gun is fantastic. At least compared with my RWS and Gamo.

Mark, PA was not very forthcoming about accepting the fact that there was an issue with these guns. At least when I contacted them, maybe their opinion has changed by now?

Mike, Did you get a refund? PA have anything to say about this lot of guns?

I didn't mind delving into my R10 to replace all the o-rings. I figured i'd be changing o-rings one of these days no matter what rifle I had, so the experience is useful. With XTXs youtube videos as a guide - oh, and ukraine airgunner for the regulator strip - it's not hard. The o-ring kits...

Yup, 3000psi will do that to you.......... That's a viton o-ring blown out the gap. 

Well, the saga continues................ I was woken up in the middle of the night, I thought a water pipe had burst. But no, it was my R10 dumping 230bar of pressure inside my bedroom cupboard. It held for a complete week at full pressure, then let go. I suspect it's the double stacked 111...

I only have a couple of spring guns to compare with, so it seems pretty quiet to me. The worst noise is as the 22 pellet beats the crap out of a 1" thick piece of red oak in the back of my diy pellet trap. So far I've destroyed two PTFE cutting boards, and a piece of poplar. I thought the red...

Mike, I bought an Ahtlon Talos BTR, 4-14 x 44 for my BSA R10. Same reticle, but in first focal plane. So far, seems good.

I've learned more about o-rings than I care to think about, but I think I have the size figured out. I asked P.A., and one of their techs said 11mm x 3mm. At first I thought he was just rounding off the 111 sized o-ring at 10.77x2.6 but it turns out that there IS an 11x3mm o-ring. I have...