KBURG's latest activity

It comes out roughly 7mm - not sure what that translates to in Murican. If you are brave a little bit of sanding could do the trick if...

Promise is a promise. I've dispatched a carrier baboon with a sixpack of Giraffe Piss Lager. I certainly wore out the Allen Thanks &...

Gents thank you for the ideas. It came down to the thickness of the gauge washer. The replacement washer was thinner, allowing the gauge...

Thank you for the reply gents. Gauges swapped out- I used them on my compressor to check that they are functioning normally, and both...

About 200 shots to date. I just installed a new washer on the gauges and as a precaution I fitted new orings on the tube.

Gents, The summary: Tank is at 200 bar despite the gauge reading zero. No air is leaving this "cylinder block" to pass through the reg...

Have you tried shooting? If it is the gauges then you have air and the gun will shoot. If it will not shoot, replace the foster.

There will be expressions of horror, but I have only managed to find a couple of very tiny leaks buy removing the stock and barrel, then...

May have over tightened gauges. Pressure is there they just aren’t reading.

You probably already tried this but did you cock the rifle before trying to fill it?

Not familiar with your gun. Does air tube have a valve, is it removable? Have you tried filling it while not on gun? If it's possible...

I experienced something similar with my Avenge-X not long ago. The gun would not hold air and I could not find any leaks. Will if it...

Pop a guage out and look at the port in the 1/8 pipe end of it. If you have a spare foster screw it on and charge/bleed it. I've had...

Cheers mate. Filled the tank up to 300 bar on the compressor gauge. Degassed using the screw on the block, which hissed plenty for 5...

Yip I'm baffled. Filled her up again, bleed screw hisses for about 5 minutes showing the tank was full. Zero on both gauges. No obvious...