Recent content by JSNZ

  1. J

    BSA Huma regulator Super10

    im in New Zealand so FAC is fine; wanting to balance shot count and power as a .22 pest gun. Mine was UK power so has the softer hammer spring, cant seem to find a FAC one around. previous owner fiddled it to high power, but the Huma should help consistency etc
  2. J

    BSA Huma regulator Super10

    Ive just got the Huma reg for my S10; nicely made and i see they have an installation guide online now. look forward to getting some time to install it. Set from the factory at 90.5 bar so will be interesting to see power output
  3. J

    Tuning Repairing a 1998 Air Arms Pro Elite

    Im in the process of restoring my UK spec Pro Elite to full power Export / US spec. Does anyone have a lead on original Pro Elite springs? The only thing i can find is the Titan which by your experience seems a little loose on the guide so will likely twang.
  4. J

    FWB FWB 300 facelift posts ..Pics

    Thanks, yes these deserve to be up and running and will likely last another 50 years if cared for!
  5. J

    FWB FWB 300 facelift posts ..Pics

    Been a while since there any FWB 300 rebuild posts so heres one of mine. Started as a left handed 300s universal stock, I got it at a very good price because it had been subject to some catastrophic incident - its seals had turned to hard feta cheese, the compression tube cracked (!), and the...
  6. J

    An Evening with the Pro Elite

    Thanks, I emailed Air Arms after I asked here and they confirmed they used Loctite 480 on them. so ill try to pick up some of that..
  7. J

    Tuning Repairing a 1998 Air Arms Pro Elite

    Thanks for that, its just a ballpark size to check against mine - in case the TP was reduced on UK models. Thanks regarding the scope. I have a 6.5-20 EFR "Air Rifle" scope that I may put on, good to hear they hold up ok. Their service / warranty is very good though in the case it doesnt. On...
  8. J

    Tuning Repairing a 1998 Air Arms Pro Elite

    Fantastic write-up. Im currently in the process of doing my Pro Elite. Ive just got it from UK (Im in New Zealand), so its sub 12fpe model in .22. Ill try and get it to where it should be - 19+FPE. From the measurements of my piston everything points to only difference being the spring! Did...
  9. J

    An Evening with the Pro Elite

    Hi Mike, what glue do you use on the seal?
  10. J

    Any guns you regret buying"

    Yes, it was more a joke - regret on the basis that buying that one has cost me a lot more money in the long run!
  11. J

    Any guns you regret buying"

    Probably my first airgun. Cometa fusion.. the gun? Great. That wasn’t the problem, the problem was that it fuelled a bit of an addiction!!
  12. J

    CO2 Pistol Suggestions?

    I would think co2 would be underpowered for such an animal.. for scaring perhaps ok but you may as well get a blank gun, but to kill you’d need a pcp pistol with decent power
  13. J

    Air Venturi V10 Match Pistol FULL REVIEW!

    Is that your pistol? Can you confirm how the sight is mounted?