jps2486's latest activity

Pellets may not be clipping, but if the hole through the moderator is not perfectly concentric with the barrel bore, then airflow around...

That's incredible, Mike. You are probably the first to develop a gun/barrel combination that shoots both projectiles equally.

I tend to agee that sorting will not completely eliminate the problem, but it will likely help your scores. Pellet hole placement from...

All scopes with 34 mm tubes are heavy. Think the SH4J is heavy? The Vortex Razor is 48 oz.!! Yikes, you need wheels for it.

Lots of theories and conjecture here. One test is worth a thousand expert opinions. I suggest tests be performed using weighted...

Be mindful that you are accelerating a pellet from 0 to around 600 mph in about 2 feet....and spinning it up to an incredibly high rpm...

Yes, but they are different animals. The SH series has 34 mm tubes and much heavier, but much brighter too.

When I shoot a 3 card 25 shot BR match, I clean between each card. I clean with a couple of patches moistened with Ballistol followed...

Note that the three supports evenly spaced along the barrel liner are intended to make the barrel behave more like a stiff, one piece...

I installed an FX tuner on the end of my 600 mm Crown barrel. Every time I pulled the trigger, the image in the scope would dance...

Almost every one of my FX rifles that I use in target competition lead up quickly after less than 100 shots. I clean then polish the...

Consider a RAW. Simple, rugged, accurate design. All rifles mentioned here are accurate in the hands of a capable marksman. You just...

I sold my m3 after getting a ghost. I feel the impact is a fiddlers gun, I was able to get really good accuracy but I always felt like I...

The only one was the Walther LGU which is no longer made. If you check the results of FT matches in the springer class, most top...

If you are new to all this, I would spend the addtional $2-400 and buy a new one. You'll get a warranty and you will get it configured...