Recent content by Joes41

I just use a 4ft folding table. The legs fold under from the end into the middle and the whole table folds in half and locks. Made out of a thick composite material. It's super sturdy and is small during transport.

I ordered one a few days ago and am beyond excited to take it in the field. Edgun is one of the only brands I haven't owned and can't wait!

You can also try paintball shops and play fields and local fire stations

Umerex USA has a tank fill locator by state on the website

I've been waiting along time for this one and after watching the review am disappointed.

High pressure pneumatics sells them on the website.

You can try target forge on YouTube or email him. I believe he was selling parts and has videos on that compressor

Congratulations!

When I first started out in pcps I built a machine that held 2 hand pumps that were automatically pumped using 18 inch sheaves and electric motor. It would work the snot out of hand pumps. The hill held up really well. Imho It also has the best technology for helping keep the air dryer.

I'm in north jersey

OK so finally got the time to sort this all out and wanted to thank everyone for the replies. I talked to a tech guy at FX USA and he confirmed that the latest 72cc plenums do have a removable valve seat. Because of the bit of extra thickness the valve rod is recessed on the magazine end...

Only have one now and keeping it. Sorry. Reach out to umerex for one

OK thanks guys. So the new valve housing I got with the power block and 72cc pp kit has a removable valve seat. Must have not been in to good and came out.

I will snap a pic when I get home later. Thanks

I'm wondering if mine just came out. Do you know if your valve rod is flush or recessed to the end of the valve when you look in where the magazine fits?