JimD's latest activity

I've had loose bolts for holding the action in the stock throw one of my guns off before too. I usually grab a chronograph when a gun...

I drilled my P35-25 out to 85% of it's .25 bore or about .2125 inches and that did not create any issues, it just increased velocity...

Have you looked at the side of the action block for the pin that holds the valve body in the block? I forgot about that pin and the...

If there is a small, like1-2 mm hole on the small end and a bigger tapered hole on the big end it may be an alternate valve seat. You...

The member in question was warned for a slight violation, using a pre-made script supplied by AGN. This kind of event happens 2 to 5...

I like this forum a lot And it has proved valuable to my growth in this hobby. I find a several of the discussion restrictions to be...

There is a very easy way to avoid a conflict with the owner of AGN on this topic. If you want to freely discuss moderator design do it...

If you haven't already tried increasing the hammer spring you should. You always want to know what the peak velocity you can get with...

I have the parts now to try and get my YH back under half an hour to refill my 45 minute bottle. It's four years old but I only use 1...

Killed more compressors than i have fingers .... todays "It's great" has turned out to be tomorrows sorrow as many times :cautious...

My first several shots were from 25 yards away with him on the metal pole of the bird house. I could not see his head so I just shot...

I have a EPL4 6-24 and I like it a lot for target shooting at 30 yards. I haven't tried it at 100 yards but I don't think it has enough...

My Arken EPL-4 looks good to me in low light except it amplifies the issue I have with the very fine (thin) reticle. The lens are big...

Depends on how fine the reticle is to me. My Primary Arms 4-14 has a nice thick reticle and I have never wanted to illuminate it. My...

Wow, that is some bad luck. My Yong Heng started filling my one tank much slower so I bought a piston/rod assembly and it just arrived...