JimD's latest activity
- JJimD replied to the thread Stoeger Updated Warranty Replacement for XM1 Bullshark Arrived From Benelli Today.It isn't BriarpatchMtn's gun but my new-to-me bullshark in 22 shot a 194 with Crosmans today and my P35-25 with a P35X barrel in it shot...
- JJimD replied to the thread N/A 10 air gun questions from a new airgunner.I bought my first airgun in 2020 but I have no plans to ever have them inspected or replace their airtubes. If you want to be...
- JJimD replied to the thread Snowpeak Artemis P15 5.5mm - location of hammer spring adjustment screw.What pennyroyal said is completely true. The way the Huma design creates extra plenum space is it pushes the regulator further into the...
- JJimD reacted to pennyroyal's post in the thread Snowpeak Artemis P15 5.5mm - location of hammer spring adjustment screw with
Like. Email Huma (great people). Pretty sure it will fit but won't buy you much in a 177. I corresponded with them about which regulator my... - JJimD replied to the thread Antifreeze in your pcp compressor?.I use distilled water with water wetter in it and I don't change it in my Yong Heng. It is in a utility room off my garage. That area...
- JJimD replied to the thread Springer vs. PCP.Perhaps. The latest spreadsheet of results for this year appears to be on page 160 of the thread on this website. The best springer...
- JJimD replied to the thread Springer vs. PCP.Anybody that thinks springers are just as accurate as pcps needs to print out some 30 yard challenge targets and prove it. The only...
- JJimD replied to the thread Giving Crosman Domed Pellets their due.I still had to keep an eye on my 2 wind flags despite the wind being only 3mph according to the weather service. But adjustments were...
- JJimD replied to the thread Stoeger Updated Warranty Replacement for XM1 Bullshark Arrived From Benelli Today.Great news. I did a little work on a Bullshark that got replaced under warranty because the baffles in the shroud got damaged. I think...
- JJimD replied to the thread Snowpeak Artemis P15 5.5mm - location of hammer spring adjustment screw.The Huma will have a paper tape label on it if it is like the one in my Caiman X. For a 177 I would set it to 130 bar. But that will...
- JJimD replied to the thread Maple Custom Products - 3D magazines.I ordered a couple poppets for my P35s and thought I ordered a 177 and 22 caliber single shot loader for the same guns from Jay. But...
- JJimD replied to the thread Yong heng compressor not filling.I had to replace an O-ring on the plate where the reed valve is in mine once. Tank fills to 300 bar are still possible with mine but...
- JFWIW. A similar issue resolved today, I think this is a reed valve in the cylinder and not in the lines. >Solved ! Tuxing advised me to...
- JI bought a GX 2, for rifle only backup, to allow time for any slow boat parts to arrive. So far, only pressure gauge on my 2019 YHeng...
- JMost PCP compressors include a "dead head" plug (pictured) for leak testing. Install in fill whip end, pressurize system, shut down...