Recent content by jaysskybound

I found that if you're looking to reset hammer spring to zero, removing the stock and turning it all the way down is best. Then as you increase H.S. little by little, I ground down an allen wrench so it fits, and can turn it ¼ turn at a time.

I haven't thought of that. So many variables....

Will do... Do you know of any upgrades to the guage? Digital? Upgraded regulator? A way to speed up pressure rebuilding behind the reg?

Sometimes I fire fairly rapid. A nice steady flow. Sometimes longer. Eg; reload, phone call, fill tube, change targets,

What is your thoughts on time between shots / temperature of the barrel? Sometimes I will get a few close-ish shots and then out of the blue a zinger or two. I typically feel like I know when it was me thar errored vs the universe gaslighting me. I can't quite put my finger on it. Maybe just a...

SO...... Your information led me to a whole new mindset. I backed off to 25 yds. And I tested 6 different pellets and slugs. I am hitting through the same hole every shot with 2 different pellets and 1 type of slug. However now I known these are consistent, I am trying to reach out to 50 yds...

Thanks for all the input. I wouldn't have had a happy face had I pulled out a course file like I did on the Red Ryder.

Spot on... I backed those screws out before getting curious about opening the trigger housing. Then when I opened trigger housing, they were laying in there loose and fell out. I watched a video on youtube about swapping grub screws. It said M4X12 screw... Not true. avenge x is defiantly...

I removed my trigger on avenge x tactical. One, because of curiosity. Two, to change out the screws so I can lighten the trigger pull. These two clips fell out from somewhere and I don't know where... Can anyone help?

Absolutely the best I've read on the internet this month. set to the balance and harmony of a Tourette's afflicted parkinsons patient chihuahua smoking meth while sitting in a paint shaker while you try to take a treat out of its mouth. it also doesn't hurt to burn a devotional candle with the...

I recently bought my first pcp rifle. The Avenge X tactical. I have been trying out different pellets and slugs. However I am extremely inexperienced in the process of figuring out tuning, speeds, ect. Past week I have been focused on JSB 13.43 knockout slugs. Just when I think I am shooting...

Thank you everyone for the input

Shooting to low of reg pressure can cause dammage to what???

This looks way easier than the ground down allen wrench I made. Sign me up!