Jay308's latest activity

For a Blue Locktite replacement I have been using Vibra-Tite VC-3 for some time now. It allows me to assemble and disassemble parts...

The VC-3 is great for things you might move or disassemble often. For normal Loctite I like to use the purple 222, on small screws for...

Yep, I just switched to all AEA

Try from Thepellet shop where they're 18.99 per 500 count in .22 Yes, they are that good...

I always thought I would hate ffp because of thin reticle at low magnification. Finding one I could deal with at 6x changed all that...

I found what looks to be a good 1/8 bsp dowty seal that is self centering. Even has a review of someone using it on a Daystate fill...

I kinda think as long as you don’t torque it hard it might be ok? There is the Outgun angle bracket that you can use the dowty on the...

Yes on the Dowty seals and I used Outgun Digtal gauges, one battery and one that you charge, I will post a picture tonight when I get...

Were they Sekhmet? Did you use the dowty seals with the new gauges?

So the regulator side read fine even though the sensing hole is on the side and not the bottom. If so, I’ll try it.

25mm Sekhmet or 28mm Wika. So you put a PTFE and a oring in the regulator gauge port?

They both have a dowty seal under them

So my reg gauge is moving in steps, I was going to replace those tiny ones anyway. I want to use sekhmet 25mm but they say not to use a...

Keep the cs2. They are 250 bucks brand new. That means you aren’t getting much money for a used one after you pay the likely 50 bucks...

It shoots tight groups with 8.72, similar to the JSB 10.3 but flatter trajectory. You do have to push a little and it pops right in the...