Jay308's latest activity

Nothing the CRC doesn’t corrode if left on. There is usually not much residue, but IPA or microfiber damp with water cleans it off.

I use the Hornady G3-1500 about $60, works well and put the pellet in the powder pan and use large tweezers to place/remove them.

I use an air rifle for hunting squirrels and birds because the ammo is cheaper than a PB, it is quieter than even a suppressed PB, and...

This. It's taken me a year to get my impact to shoot heavier slugs the way I want just under 1000 fps on a crono. Sure it will send...

Ring torque is good 15 in/lbs, same torque driver that I use on my 2k+ scopes. I’ll probably send it in to Athlon for them to check...

Success! After remount, I ran the turrets through their full range, reset to optical center using the manual, then re-sighted in. I also...

Vey nice!

At the end of the day it probably doesn't even really matter. The Impact was a hot ticket item in 2019 and everyone had to have one and...

Everyone want to like slugs because they are a “bullet” but they can be pita to tune a pcp for. You are not at a disadvantage using...

Are you using a springer? Usually when someone says they shoot over 1000 fps, it has Gamo break barrel written all over it. Pellets are...

I shot with the Athlon but the windage didn’t move the poi until almost a full rotation, wtf. It’s not far from optical center either...

If want to use a small diameter Donny, then get the Koi, the tanto was loud on my Maverick 600mm .22. STO Falx is where it’s at for...

No but the M4 will be out and the M5 will be in soon enough, it’s the FX way.

I've got one on order!

Thanks for the info. I mounted the Athlon, going to shoot tomorrow. If it’s consistent, I’ll box up the SW. Just a hard thing to...