Recent content by james509

  1. james509

    Maverick Bottle change almost impossible!

    The same thing happen to my Mav. Bottle never was easy to remove but got worse with some time on it. Got to where I had to go 1/2 turn off and a 1/4 turn back on to get it off. I called Utah Airguns where I bought it and they took care of it right away. I haven't had any problems with the new part.
  2. james509

    Tuning Strange 30 cal Maverick fill problem

    I think I found my problem, 2 bad gauges. Utah Airguns were nice enough to send me a new gauge but it reads the same as the other. both way off. I put the one off my Impact and it was still 10 bar off but much closer than the others. I'm ready to just buy one for my new Maverick but how do I...
  3. james509

    Tuning Strange 30 cal Maverick fill problem

    I'll try swapping the bottle with the Impact, That's easy enough.
  4. james509

    Tuning Strange 30 cal Maverick fill problem

    I just got my 30 cal Maverick sniper and have a strange problem filling it. No mater what I do, it will only show 210 bar. I have over 250 bar in the scba tank but the gun will only take 210. I figured it was a bad gauge so I replaced it but the new one reads the same. I have an Impact and the...
  5. james509

    Another new .25 cal. slug worth testing. Nielsen Specialty Ammo (NSA) 34.9gr.

    I've also had pretty good luck with the 36.2s. They seem to like around 950 fps, I had some dime covering groups at 50 yds but they were opening up to about 1 in and a quarter at 100. Could have been the wind, maybe...
  6. james509

    Another new .25 cal. slug worth testing. Nielsen Specialty Ammo (NSA) 34.9gr.

    Nice write up, I've had a box of the 34.9 for a few weeks now but it's been so cold out I haven't had a chance to give um a try. I have about the same setup, 25 cal, 700mm slug A. Reg at 150, I can fling the 34.9s over 1000 fps so I'll have a lot of range to play with. Glad to hear they're...
  7. james509

    WIN a Kalibrgun Argus 60 PCP and More!!

    1509.95
  8. james509

    Will my Impact X benefit from the larger valve housing and rod?

    Good one. I like your buffalo comment. My gun is the most accurate around 960 but I thought it might help to up the fps and be able to back it off with either the reg or the hammer spring.
  9. james509

    Will my Impact X benefit from the larger valve housing and rod?

    Yea, it's probably just fine the way it is but I can't seen to fight off this urge to tinker with things.
  10. james509

    Will my Impact X benefit from the larger valve housing and rod?

    I have a polish plenum already with ported duel tp, hammer weight and alot of other mods but I still have the original X valve housing and rod. The removable valve seat has been bored to 6.3mm or 1/4 inch. I'm shooting 36.2 NSA slugs at 1010 fps with 150 bar, 18mm gap on max and 3.5 lines on the...
  11. james509

    WIN a Daystate Red Wolf .177 HP PCP and More!!

    Far out and solid 509.00