Recent content by jackrterrier

231.76

Tom, Have you done (or can you recommend) a good youtube video on tuning the marauder? I am not talking about messing the with the valve, just the port on the back of the gun (where you can bleed the air out)? From what I understand, there's a couple of things you can adjust using 2 different...

Tom, I'll try to answer your questions... I am the original owner. I have no idea if this is a Gen I marauder - how do I tell? (obviously I am a neophyte) How many shots? I dunno, not a lot - 200 or less? It is the original valve. I may have adjusted the hammer - I dunno, I really don't know...

bought from archer airguns

my google searches are useless today. can anyone send me a link to a website that sells the entire valve assembly? I want to buy one but I can't seem to find it.....

Tom, Appreciate the answers. I tried to pressurize my marauder this morning, but I'm losing air out the end of the barrel. Perhaps I put things back incorrectly? Any ideas off the top of your head? Thanks

Tom, thanks. Got it in there. The problem with the o-rings I bought is they send a pack with a bunch of o-rings, but you have no idea where they go, if there are spares...

New question - I ordered a kit of o-rings, and there are several sizes. So I'm looking at the exploded view and partslist diagrams for the 1763, but of course, I can't figure out which o-ring goes where. Well, most of them I can, but not all. In the diagram, part #10 is o-ring 1.5mm x 4.0mm...

yeah much better pricing on those o rings, thanks

Tom Thanks, I might try the 600 sandpaper. The tube is empty so I'll clean it afterwards if I decide to do that. I bought o rings from 'captain o-rings' - they were crap, will never buy those again. this is what I've gotten the last couple of times...

thanks for all the suggestions. the problem starts at the threaded end of the pressure tube. I think on the gauge port assembly, when I push the first o-ring in past the threads, it gets hung up and comes out of the channel where the oring sits, and then gets between the inside of pressure...

Trying to replace the 4 1763-026 o-rings that go inside the pressure tube - 1 on the valve assembly, 2 on the gauge port assembly, and 1 on the fill adapter assembly - I keep chewing up the o-rings on the threads at the end of the pressure tube, where the fill adapter screws in. Especially the...