JackHughs's latest activity

If you should decide on a GX CS4-i, I suggest that you first consider the CS4. The CS4 has an external power supply which will not be...

I have one that was made long before RAW offered them for sale but it's almost exactly the same. It was made by a friend of a friend...

There is only one hammer spring adjuster. Each click on the Micro wheel moves the adjuster a fixed distance. Each click on the Macro...

A friend had a similar problem with a new CS4-i. The culprits were a faulty power supply and circuit board. Try running your compressor...

I tied that. I still had to carry the 9 liter tank back and forth from my truck. And, I had to load and unload the golf bag cart from...

I have a CS4-i compressor that I use to "top off" 9 liter tanks. I recently purchased a Tuxing 3 liter tank and used to the CS4-i to...

I bought mt CS4-i direct from GX. Good fortune smiled and it's operated perfectly from the start. A friend bought a CS4-i direct from...

Consistency in spades! Nothing I've experienced in the past can match this type of consistency. The Mora in .25 caliber is quite simply...

Two more possibilities come to mind. Check the bleed valve on your tank to make sure it is 100% closed. And, check the o-rings in all...

Molecular sieve absorbs more water at lower humidity levels than silica, the end result is much drier air.

I agree. Too much grease may be the culprit. This is a long shot but the problem might be a failing power supply or circuit board. A...

I didn't know there were airgun related posts on Truth Social, X and TikTok. JackHughs

Mine is silent so far.

MY CS4-i does expel grease - not a lot, but enough to justify the small filter installed on the output. JackHughs

This one. https://www.amazon.com/VerRich-Water-Oil-Separator-Pressure-Compressor/dp/B08MLBB7T4/ref=sr_1_58 JackHughs