JackHughs's latest activity

50 yards, 3 shot groups Impact M3, JSB 44gn pellets, 880fps 700mm 1:22 liner How about them apples Very satisfying shooting video...

Your FX gauge male threads are G1/8 BSP. The adapter shown has a 1/8 NPT female thread. It won't work. The FX gauges are sealed with...

I recently bought a 3 liter bottle with fill valve and whip for $206.00. It fills to 4500 psi with no strain on my GX CS4-i and...

So far, my .22 700 Panthera is not sufficiently accurate to notice any POI shifts. JackHughs

As always, check the thread diameter and pitch before ordering. I read somewhere that the gauges installed on Kratos, Akela, and Caydon...

I have a Benjamin Kratos and an Akela. The gauges on these are as cheap as they come. Amazon gauges would be OK but be sure to get the...

I'm not an expert in either regulated or unregulated airguns. I did record some interesting data from my unmodified KRAL manufactured...

I use a GX CS4-i to top off 9 liter tanks. The compressor is perfect for this task. One other member of this board has used the same...

New thermister in place and works a treat.

My favorite is a Benjamin Kratos. I find it aesthetically pleasing, accurate enough, and fun to shoot. JackHughs

I just put one on my 3l. I like 'em in part because they're easy to throttle your fill rate...

I'm going to buy the 3 liter Tuxing tank and the two gauge valve with the added fill fitting. The extra gauge is not needed and the...

Yes. I've replaced two single gauge valves with duals. I got one to install on a new bottle. Liked it so much I ditched the others...

The valve on the third tank from the left looks very similar to the Tuxing valve in question. Does it have a direct to tank fill...

I'm getting old and feeble so carrying around filled 9 liter tanks is becoming an unpleasant chore. Tuxing sells a three liter tank...