JackHughs's latest activity

You beat me to it. I had planned to ask if any of the forum members would please measure and post the the output (under load) voltage...

Uodate: I have a CS4-I that worked properly right out of the box. So far, so good. As I mentioned in a previous post, I purchased a...

I agree. Check the alignment of the transfer port in the barrel with the transfer port in the action. Also, this rifle should have two...

There is a thread somewhere here where someone found some burnt out electrical parts on the inside and was able to fix it. Just in case...

Thank , I have a gallon of the Seco Lube 500 on the way. $146.28 total shipped from KG power systems. I only used the RP For the initial...

You have a CS4 with an external power supply, correct. A friend has a CS4-i with a bad internal power supply. He bought this power...

Success. My friend purchased a 600 watt 12 volt generic power supply and hooked it up to his disabled CS4-i. The pump works like a...

I cleaned the check and boy was it gummed up. Working great now even sounds better! Thanks Guys!!!

Wanted a longer barrel but not a longer OAL and to keep it looking original. 16" barrel. It's one of the rarer ones in .25cal shooting...

Thank you both. This is exactly what I need. A friend bought a new CS4-i that was delivered with a faulty internal power supply. GX...

S-650-13 Input AC85-145V (50/60HZ) OUTPUT +13V 50A

Hope this helps.

Good morning. If you have a CS4, would you please post the nameplate data for the external power supply. Thanks JackHughs

Start the compressor with the bleed screw open. Let it run under no-load for five seconds or so before closing the bleed screw. JackHughs

A friend recently purchased a CS4-i and had similar problems right out of the box. GX advised him to test the compressor at 12 volts...