JackHughs's latest activity

This sets a record for me as 9 air guns came in today! Will unbox and share what’s inside later. At my age I can’t fool around...

As one of the least mechanically inclined AGN members, I ask a lot of questions and sometimes need to read and re-read posts before...

Found this little janitor cart here on govdeal for $15. It was local pickup only but just figured I'd throw it out there if anyone wants...

Many, many years ago, I purchased a Unertl block to Weaver mount scope adapter from your friend. I considered his rifle rest as well...

This rest was made by the local High School VoTec Precision Machining Program. It has been sold in close 50 countries around the world...

Vintage stuff. Hart pedestal, Sinclair speed screw, genuine Fudd windage top, Edgewood bag. JackHughs

Airman is spot on. At 135bar you’re most likely not going to be valve locked with a heavier hammer. For reference, I am running stock...

So my entry to the world of PCP began with a couple months of research before finding the forum here, tons of great info and some very...

Speaking only to accuracy and precision, this is an important question. Most consumer class Sound Pressure Level Meters can be set for...

Are you sure the decibel meters can respond quickly enough to the shot sound?

H&N 99.63 Pb / .37 Sb JTS 99.87 Pb / .12 other JSB 99.99 Pb AEA 99.77 Pb / .22 other I didn’t bother to dig around the PMI gun settings...

You might try this. Deadhead the output hose. Start the compressor with the bleed screw open. Run the compressor with the bleed screw...

Lots of good advice here. I suggest the least complicated approach to get started. Talk to the folks at your dive shop about their...

Remove knob, then remove spring.. Replace knob..

If you are talking about the valves on scba tanks such as scott firemen tanks, then you can just screw in the nut and it will do the...