Recent content by j.quillin

Traded no longer available

bump

NM SHOOTER here's the other side of the stock. Just mirrors the other side.

Palmetto, PM'd you back.

The MDRL is an ambi stock. Depends on how you set it up... A lot depends on regulator and spring settings. Mostly looked for a balance of shots and power. with the 7# spring in it, With JSB 25.4gr i was getting around 32 shots @ 840fps avg / 40FPE before falling off the regulator. With a #10...

Up for sell is my regulated .25 marauder. I upgraded to a Cricket .25 so I'm letting my sidekick for the last 2yrs go. There have been a few upgrades to the rifle but nothing too extreme. Upgrades are as follows. Huma regulator, 5000psi gauge, Air stripper muzzle device, wicked shroud extension...

Skipster, PM sent

i completely understand. i'd like to be able to keep it, but after buying a cricket at 3x the cost of a mrod something has to go. Granted most of the mods i purchased for it that are on the .22 mrod dang near made it as costly as a cricket. 

Yeah, I'll do $525 shipped. Paypal as family or gift is preferred. Nice choices for other rifles. I currently have my .22 mrod in a mdrl stock that I refinished. Almost got my cricket in the bigger calibers http://airgunnation.dev/topic/mrod-mdrl-stock-refinished/#post-70780

but if you eat enough glitter it will twinkle.

Its a gen2, besides the adjustable comb, another give away is the breech mounting bolts. Gen2 have 2 recesses at the top corner on each side where the breech mounting bolts go through to the air cylinder, Gen1 has 2 recesses in the front and none in the back, the rear mount bolt was done...

bump $275

bump $525

I find that my .22 shoots better with the shroud secured by either putting an bigger o-ring in the factory barrel band or the barrel band with set screws to hold it in place. But it is really fussy about pellets. Really the only pellet it likes is the 18g jsb wich does an 1" group @50yds