Recent content by indubitably

I like all Wiha tools. German quality and good steel. Snapon has amazing metallurgy and their tools hold up very well. Some of the RC tools are good with reincertable bits but the Wiha are what I like for the airguns. Snapon for cars and motorcycles and RC tools for RC cars. All good stuff...

Our local Scuba store has a great compressor which can handle such pressures, and how much more would it take to go further? In reality it may be a steeper climb than i thought. And cost logistics might just push this back for some time. There are some very knowledgeable and experienced...

I keep thinking that the newer tanks with 5,000 PSI or more will be released soon and we will ge more fills for the same size tank. Every PSI above the fill pressure of a gun will mean more fills. Not sure why the pressures aren't being made available sooner. I believe the Fire men are into...

So If consistency is what accuracy is all about, then a - say 5 degree cant, consistently held might be workable if A distance is zeroed in. Predictably, but not established in my experimentation, corrections on windage and hold over would both be needed for distant or proximal targets, even...

Im thinking that with the new air bottles coming out with 5,000 PSI capacities and the more shots per fill that will be realized with the higher volume of working air in the same little cylinders that higher pump pressure will be needed. Any idea if that might be considered by the pump...

Make a list of what you have Make model and calibre, and year of purchase or manufacture if you can Im curious to see what you have. You can list them here without a price, that way no one will think you are trying to sell them. Then list them individually on the sell forum so we know that...

Not sure what I read here or what I learned

Solo 1 You mentioned the barrel tensioner. If I think correctly you are referring to a spacer between the shroud and the block of the gun which keeps the barrel from wagging? Im questioning if this really makes a proven difference. Or is it just appearances in closing in a gap? If it really...

I like Bushnell, and have had respect for their products.

If you take the liner and barrel and shroud all off you can look down the liner and see if the liner is centered in the barrel. I noticed a little lip and when I placed the carbon sleeve over the liner there was several inches of bare liner not covered by by the carbon sleeve. There were three...

I just notice the ballistic turrets on the Schmidt and Bender Scope. Can a turret be interchanged with another scope? Probably not but somethings like this really seem outstanding. Instead of Stickies these tabs can be moved around and fixed with little set screws.Possibly these may fit on...

Diamond cut off saw. Use a mask as the fibers are not healthy. If you have an indexing saw just fit a Diamond blade to it and get a good 90 degrees. Go slow or the heat will leave unsupported fibers. A tile saw with water would be good if you can get a good 90 degrees on it. You can sand it...

Its simple to understand a sear trigger for mechanical airguns and fire arms. Something slides then releases and sets in motion what results in the release of air or fire to propel the projectile. So with an airgun I imagine a circuit is closed and a motion set into action for air to propel...

I get excellent service there

IT is pretty easy when you compare size (length and diameter). The harmonics are more about frequency due to velocity. So as you vary the fps of the projectile you may notice one as more effective than another. Other wise the bigger the more silent to a point. Quality is always important. So...