Recent content by iFish

When I got my L2, it arrived with the digital gauge and the battery was dead. That convinced me to change the gauge out with a wika analog gauge immediately. Yeah I know an alternate gauge will cost me more than batteries, even in the long term. But, the hassle factor of having to constantly...

My name is Jim, live around Austell GA, fairly new to airgun's, but have owned a variety of powder burners over the years. Currently retired and have gone down the rabbit hole. Look forward viewing / reviewing all of the great info available here.

According to the "old" schematic,, it is М4х8 10.9 DIN913. I say "old" schematic because the basic design is there, but there have been many mods over time that just aren't reflected by the schematic I have. That said, I believe what is stated for the grub screw is accurate.

These are now available and I just ordered one. I did a jaw tightening at the price, but it is what it is. Hopefully, my hissing trigger pulls go away with this. Edgun Leshiy 2 Alpha Trigger Here's the install vid

Mine leaked in the same spot when brand new. I had a very hard time getting it to stop. I finally did after cranking down on the grub screw a lot tighter than normal. I swapped grub screws around as they are different and that finally did it. There has to be a mfg flaw there or something, though...

Did you run it AC or DC via the Ecoflow?

Yeah, I have the TNC635R and that's one of the reasons I went with a riser instead. The other is the price. Just can't justify the price of that thing.

Just ran across this. A bit expensive for me. https://tier-one-usa.com/products/universal-base-mount-thermal-optics

The DNT TNC635R comes with 2, the 0 MOA and the 20 MOA. I find the 20 MOA works better as I don't have to move the reticle as far when zeroing the rifle.

I have a Leshiy 2 and have the DNT TNC635R mounted on it. Scope placement is a bit to far forward. If I could move it back more, I would. It's as far back as I can get it. Further back and it interferes with indexing of the magazine. The mount design just won't allow it. That said, it's still...

All said is true enough. It's the eye relief that stopped me from getting one. So, you can permanently mount the scope to this, and then this to the rifle. I know you can zero the DNT, not sure about other scopes as it may raise the scope to much <shrug>...

I just got the GX CS2 for 266.00 via Amazon prime days. It's 278.00 on the GXPumpOfficial.com website. So, Amazon is cheaper, until you add tax. Not sure if the GX website charges tax. If not, it will be cheaper there. Got it as a spare in case my CS4i stops working.

I have this scope and it's clear.

DNT has one. This is the US based website. There may be one based where you are. Not sure, but Go here https://us.dntoptics.com/products/adm-american-defense-manufacturing-ad-170-s-bsae