Recent content by Honoo

Hey, I contacted fx support and they told me it fits as long as I use the new seat as well. Once I sort out the parts (hopefully), I will post an update. Thanks for the interest.

Any idea what that tool is?

Good morning all, The main question, will the newer model fx crown valve pins fit the older gen fx crown? I have a first gen crown, valve pin has the black derlin on it. Here is why I am asking: I replaced my valve seat with a 6.35 seat. It worked fine except for the following: - When...

For the install, I just used the tip of a pen to drop it in the right direction and center, and a small Allen key to push it in a little from different sides then I just used the other side of the pen to seat it.

So to close the topic, I wasn't able to get that tool quick enough and the valve seat cannot be pushed from the hammer side as the opening at the hammer side is smaller than the seat ID. What worked for me finally is to lodge my 5.5 pellet probe in it and pull it out. I imagine that got it...

Thanks a lot, I'll try that.

Thanks a lot, I'll try that way.

Hi guys, Any idea how to remove the valve seat on the fx crown? I may have pushed it in while attempting to remove it stupidly by trying to widged a pice of plastic in it. Any idea if I can push it from the hammer side? What is the tool Ernest is using here to remove it? If it is the only...

It is a first gen crown with a huma reg (not the high pressure version). What I find strange is that it is at 130 and I am only getting 820 fps. Is that ok? Thiught I should be getting around 920 or so I wil see about adjusting the hammer further. 

Hi My crown shoots JBS MKII .25 great at a very consistent ~820 fps with reg pressure at 130. Any increase to the reg pressure would cause the speed to drop drastically to around 720. Any ideas what is causing this? Hammer not hitting hard enough? Or reg problem? Thanks

Sorry printed on the side Piston is 16mm but springs are 8mm. Still a gen1 though based on fx response.

If anybody is interested or finds this topic through google: My rifle is an fx crown gen1 (serial number prior to 180760) but with a 16mm piston AND 8mm springs, I measured it earlier I said it was 10mm lol. How embarrassing. The set screw is not domed I think. Looks pointy. The generation...

So, FX confirmed it is a gen1 rifle. I returned the gen3 for a gen1 but again an issue arise, it came with only 8 springs lol. I contacted huma and they said it should have two bags. I am beginning to hate this and might give up soon. The original springs seem identical. Any idea if...

Engraved on the side

I bought a huma reg, so would rather replace all of it. Just waiting on a response from fx regarding the generation thing.