Hobbyman2007's latest activity

I would try to find a .20 and return it to factory. No experience with the RX1 or 2 but have had a couple HW90’s in .177. Way over...

No knives to post, but do carry a bench made bugout everywhere. The rifle is a shortened barrel (16” ) MK2 Rapid in .25 cal with some...

One of my favorites to carry on dog walk

Cutting as in Machining it ? or cutting shorter etc ? Carbide for machining Fiber blade chop saw for shortening etc ...

I made a new valve housing from delrin. I bought a 3/4” x 6” piece from Amazon for less than 30$ CAD ( snow pesos) much more cost...

I have to ask. What’s the trick to cutting a hardened hammer. I’ve tried a few times but never had any luck. Different tools , carbides...

Nice, the longer barrels can really shine. I did a polishing/lapping the ceramic ball pocket in my REPR somewhere early days when that...

You’re saying a “10%” increase. The model I was looking at was priced at $23xx now it’s at $ 28xx. How is a $500 jump 10%? My math...

I absolutely never look at anything labeled Daystate.. the couple I got curious about I found out had electronic triggers, digital...

Your barrel seems real tight but can be made to work IMO. 1:16 is the wrong twist rate for light pellets ( under 25 grain) get the...

Go with the Ghost. Too many options to list them all , I’d go with the longest barrel available.

I’ve gone through close to a dozen TJ liners from .172 through .357 in both powder and pellet barrels. Two out of that bunch needed some...

Using the bottom plug . Not the front plug. I’ve got the parts here somewhere in my mess but I never installed them. I run my Rapid...

I’ve got a few that shoot my own cast as part of the fun is to get bullets sized to the correct diameter. First is an Evanix K550 (...

It would certainly work , the issue is the very small volume in these fittings . Not much gain from the 5 or so cc’s af air. There are...