hgatesm's latest activity

you need to go the other way, if your group is getting wider with speed, start closing the valve maybe 1/4 1/8th turns in at a time take...

HAHA as far as that goes this has been a one sided abusive relationship. Finally getting some therapy:ROFLMAO:

The impact is a demanding mistress… but once you know how to play with her she’s lots of fun ;)

Now that I have burned a few hundred dollars in ammo, might actually get some results! However I am completely okay with redoing my tune...

Very good then ;) c3 at 5.8mm is perfect. Now you gotta redo your tuning though.

Ya'll were correct again! Removed the little rubber ball from the valve spring as suggested in an earlier post and gained a significant...

Ahhhh okay that is making a little more sense, so on tomorrows list of things I need to buy,, a set of calipers.... So if c3 isn't...

Well, that will be an easy fix for tomorrow, at least as far as removing the extra little ball. I guess I am not sure what the c3 is?

I'm not sure what c3 is. If its the piece at the end of the valve rod, yes I am certain that it is tight. You also mentioned rubber...

Reg ended up sitting just shy of 150bar, micro is almost maxed out and macro is on line 14/16, I couldn't gain any more velocity past...

Thank you all for the information, I got out and shooting this evening with what little daylight that I had. Per the above posts, I...

I have a tungsten hammer here and ready to go, also have pin probe installed as well

700mm barrel shooting .30cal

What would you recommend for reg pressuer as a starting point? Watching Matt Dubber on YT, he's pushing like 170 bar on that reg. I have...

Gotcha, making some sense. Trying to get this darn gun to shoot accurately has humbled me infinitely more than what I thought was...