Recent content by hegshen

Zelos?

Does anyone have pictures or video of the rebuild process? Erik

2665.25

$20.26

626.56

1123.46

626.20

I have a nomad ii compressor and does that mean that I should stop using silicone as a lubricant and switch to a synthetic like mobil 1?? hegshen

$666.65

I have a BSA lone star which is essentially a scorpion. 22 cal FAC. Shot my best 100 yard group with that gun a few months ago. Shot count stinks but it’s still as accurate as any gun I’ve shot.

I’ve got a crown continuum synthetic and want to put a front pic rail on it. I was hoping someone could share tips on placement, screw choice and successful technique. I did watch Tom’s video but that was done on an Fx royale and not a crown. Stocks are a little different. Thank you for any...

I’ve left the regulator set at 130bar and adjusted the hammer spring tension with the power wheel at max shooting at 815-820fps. Velocity doesn’t start to drop until two clicks from max power. My power wheel appears to have a two additional detents compared to my gen 2 crown. It’s like I’ve...

I maxed out the hammer wheel at 130bar but the highest velocity was still about 820fps. It achieved this velocity early on in the adjustment of the hammer spring and despite the increased tension no improvement in velocity. these were the same numbers I got when the reg was set at 125bar from...

Were you getting those numbers from a stock continuum or after your mods? I’m not planning on doing any mods at this time, so was looking to see if anyone one would be willing to share their tuning experience to get numbers where the 18.1g are moving at 850+ with the stock setup and the 380mm...

What settings do you have you regulator, hammer spring and power wheel set to for those numbers? I chatted with the guys at Utah airguns and they gave me the impression that the Max velocity out of the 380mm barrel was about 820fps. That seems to be my experience so far. Thoughts? Erik