Recent content by HajjitheDoberman

Took Amazon three shipments to get me the correct compressor, and during the drama, they cancelled my extended warranty for no reason. Not my normal Amazon experience. Third time was a charm. My CS3-I has been great for the 8 hrs it has been used so far.

Online, since no gun stores seem to carry Pardini 10-meter air pistols, nor the similar Olympic rimfire pistol, for that matter. Seems Bullseye is an old fogey’s sport, going the way of the dinosaurs. I feel old😥 🦖.

My scuba had been only partially filled When I filled the three cylinders for the gun. Next test will start just under 250bar.

I received the light bars for my Competition Electronics digital link chrono today. Ran 10 RWS 7.0grain pellets through the Pardini K12 at 140bar. Pellets all in the black.🥳 Extreme Spread of 4 FPS, Standard Deviation of 1 FPS. Average Velocity 10 Meters from the muzzle was 544 FPS. Second set...

Superb! Thanks for the info and the pics. I'll check my local dive shop Saturday morning. Gracias...:love:

YES, EXACTLY.

Thanks✌️ First I have seen anything about HAM magazine. Looks informative and interesting.

GX CS3-I. A tad noisy, but It works well.

I shoot Bullseye with a Pardini SP-22 Olympic pistol, decided to try a Pardini K-12 for Air Pistol Bullseye 10-Meter practice in my garage. After a few hundred pellets downrange, the air cylinder dropped from 200bar to 70bar. Pellet impact went from X-ring to below the black, several inches...

Here I sit, normally I would just install a short NPT Nipple and be done. But, I have no idea where to find the correct nipple to mate two Female DIN pieces. Of course, I would like to locate a bleeder valve to place in the 1/8 hose lines to allow slow depressurization. I have tried several...

Pardini K-12 has a true Dry-Fire mode, in which you cock the pistol, move the Safety selector up past the Safe position, and dry-fire. This method lets the trigger work as in normal use, but the air system is not used. I don’t know if other Olympic type pcp’s have this feature, mainly because I...

While my GX CS3i has the Amazon Extended Warranty, I would prefer to keep this little jewel running, without going through any warranty hassles. Can any users recommend the areas needing cleaned, lubricated or replaced at intervals that will lengthen its lifespan, along with the type of material...

I have one of these on my GX CS3i. I just place it under the compressor carry handle. It works fine. AIMILAR Vibration Hour Meter - Waterproof Hourmeter for Gas Diesel Engine Motors Lawn Mower Air Compressor Sold by: AIMILAR Return eligible through Jan 31, 2024 $12.79 Condition: New Buy it again

Thanks folks! You are all quite helpful at showing me the various messes facing me in regards to fittings. I think I’ll need a stiff drink to face these multiple variations.🤦🏼‍♂️

I received a new fill set today. It came from Best Fittings, and seems to be of higher quality than some of the other hoses and fittings that I have. Seems like everybody sells hoses with female quick connections, leaving me with a pile of excess female quick connections. I weed them out so that...