Recent content by gunnerf250

A little knock off dremel and cheap Amazon rail adapters and I got it to work a new squirrel gun is complete

The Dove tail to pic rail adapter looks like its going to add some length to the rail might have to bubba it and trim it with a cut off wheel

it actually was an issue for me it was off vertically so that's why I'm going with only mounting it to the rear rail

I found a cheapo dove tail to pic rail adapter and I'm going to give that a try since the scope came with rings

So I have a Hatsan jet 2 and I want to mount a leapers accu shot swat compact scope to it. In must be something that can fit of 2.8 inches of rail.... any ideas?

Welp an update I still cannot fix my issue with the Gauntlet 2 even after replacing the O ring in the fill nipple and replacing the nipple itself so now I am replacing the reg.

thats the area of the leak also i went a ahead and degassed it and once again air came out of the fill port prob thing how normal is that?

Thank you for the info ill try it and see what happens

I have an umarex g2 that has a slow leak... I can fill it up the night before I got to shoot it and by the morning it will be down to 1k psi. This did not start until I degassed it and when it was degassing the plug that fits over the fill plug popped off. Was wondering if anyone had any ideas...

so I was an idiot and found out i had installed the suppressor wrong ie I didn't put the spring from old shroud in front of the new air stripper causing the air stripper to move enough to knock of the pellets trajectory and having it damage the suppressor. Luckily the quality is good enough...

it's accurate enough within 60 to 70 but it looked like it was getting a bit wobbly at 100 also as a side note the short shroud adapter for the g1 from donnyfl should work for the g2

mine shoots jsb 33.95 at 900fps which is still a little hot for accuracy