grouch-o's latest activity

there are some interesting videos by G.K. himself, showing what i consider good results with vers.3 mp mold slugs and in a later video...

AEA uses some cheap plastic for their valve pins in spite of knowing full well about this problem - I was told by the guy i bought my...

are they breaking often? why are they breaking?

how's the plenum holding up? i like the idea, but am afraid of leaks after the operation.

Since it was first announced, i was intrigued by the MEG and really excited to see what it will be. top or flop? now after quite a while...

update: i did get the regulator out. pulling it towards the bottle/muzzle direction from the tube. i think there is a slight scratch on...

I removed that one and installed 3 larger OD gauges between the compressor cylinder and the tanks. Cross checking works more reliable...

All a a bit different bud. In general, if you make a mark on the reg’s adjuster and make a 12 o’clock, 9 o’clock, 6 o’clock & 3 o’clock...

anything for this press, too? supposedly a LEE CHALLENGER.

what is the right direction on the HP version? i tried pulling the regulator out with a long 4M screw that was screwed into the brass...

На v3 они могут быть повреждены резьбой при установке регулятора в трубу.

а сам регулятор вытащить нельзя? или пробку открутить?

thank you all for your responses. they are helpful to me.

This is what i think must have happened, not by the threads, but by sharp edges of the borehole inside the tube. because before i tried...