Recent content by Good_Enuf

A recent posting by Heinz Reinkemeier at is video of a similar extensive controlled damaged pellet test, specifically for 10m precision shooters. Similar results were obtained. He has many videos on all phases of precision airgun shooting. JE

A very recent video reviewing the Hill EC3000 made it onto you tube last month. Most valuable to me was the reviewer's precise measurement of water capture by a desiccant filter at the discharge end of the system. He ran it for 13 minutes to fill a 1.1 liter bottle from 200 bar to 300 bar, and...

The answer to the thread compatibility question may be more tangled than you think. The "G" designation is British BSPP threading and is not universally compatible with anything but itself. See this link for a complete explanation: https://findanyanswer.com/what-is-a-g1-4-fitting I have...

Amazon has several suppliers for these fittings, but none so cheap. Be aware of shipping problems now troubling merchandise from both Europe and China and be prepared to wait it out - if they say up to 5 weeks they mean it (sometimes). The delrin rings are also available, but judging from the...

I have been thinking about an air dryer filter on the intake side of my Hill compressor. Can you describe your set-up? Did you tie into the threads used to connect the stock filter to the intake check valve, or did you keep the original filter and Rube Goldberg the dryer in front of it? If so...

..."Here is an o-ring chart I have used many times. A caliper can cost as little as $10. It is a must have tool if you want to be independent and service your own equipment. https://www.marcorubber.com/o-ring-size-chart-as568.htm"... Thanks for the link; it would have been helpful in...

Going back a few months, I've seen several requests for info on parts availability for the Hill compressor. Go the the Hill website and click on top store item "Electric air compressor". You will be immediately be presented with the EC 3000 and service parts for the same, presented in kit...