Recent content by get2anthony

I've the same question! If someone figures this out, please post. I will do the same if I can sort out the sizes. Especially need the BK29.5 (16-9124) o-ring size. Cheers!

613.67

613.67

All, So again, I had to go back, review and investigate based on the most recent discussions. I have CONFIRMED with Synco that both 93003 and 92003 are acceptable for use with the o-rings, materials and pressures in most, if not all, PCP airguns and air tanks. These two products are Silicone...

Hmm. If Synco is not recommending I will go back to Trident that John referred to above. I will also consult with FX Airguns on this as well. I will post what I find out. Curious as to the reasoning Synco might have given for not using with high pressure tanks?? It is approved for sealing...

Superlube is what FX Airguns USA uses and recommends for airtube threads and O-rings. You can use it for all orings anywhere on the gun. I’ve even used it on my Hill Hand Pump MkIII without issue. 

613.67

613.67

I've been looking for a good PCP pistol. So few good ones out there that provide sufficient power. And that 'standard' length one looks great!

EDITED FOR SCOPE DIAMETER ERROR. (The scope was initially listed as 4-16x56. It is a 4-16x44. All other aspects of the scope remain unchanged. My apologies for the error.) I'm selling guns to keep the wife happy! You know the saying... The first offering is this Gen II Benjamin Marauder...

@MODERATOR, I totally agree with @thane and @Hepotter. @WesBob has been very helpful to the AGN community, ESPECIALLY with the PP750. As others have mentioned it's extremely difficult to get accurate information on this item in North America. Further, I hate 'advertising' and generally I'm...

In response to @thane, I had this same skewing badly on mine. I've only managed about a dozen shots out of it before it binds from skewing so badly, you can not cock the gun. I didn't completely understand your explanation but gained enough that I backed out the machined bolt screwed in the...

I had this skewing badly on mine. I've only managed about a dozen shots out of it before it binds from skewing so badly, you can not cock the gun. I didn't completely understand your explanation but gained enough that I backed out the machined bolt screwed in the pellet probe to test if that...

613.67

The slide is aluminum, thin aluminum. There is very little plastic on this gun - a nice departure from most!