Recent content by Geezerhood

For my powder burners, the scope / mounts are the first thing I would suspect. On airguns, it has almost always been the complicated barrel / shroud combination that causes POI shifts for me. It has RARELY been the scope. My FX Impact was the worst of all my airguns. My lowly Notos still holds...

Simple can be great. What did you use so you can disconnect your gun without losing the air in water traps / filters between the pump and the gun?

Image with callouts

This setup has worked well for a few years now. It leaves my water trap and carbon filter completely full of air for months at a time and I can connect / disconnect guns without losing pressure and start up my compressor with no load without emptying the large water trap and carbon filter...

Thanks! I am replacing two pistons soon and will check that O-Ring. I have a ton of O-Rings on hand.

Where is that part found?

My Uragan 2 in 22 cal was SUPER loud because it was supersonic from the factory with most lighter pellets. I tuned it down inside on the regulator (no amount of external adjustment made any difference). Now it is my most quiet and accurate air rifle, without the need for an external moderator...

Sorry, never saw the notification. I had it set on the lowest sensitivity which I assume was Sen 1, but I can't check it as it is now DOA, about one month past the warranty. I cut into it to see if I could replace the battery, but so far have not been able to find the battery in there. The PCB...

I have used both. The direct powered one was wired into the pump motor connector so it only ran when the pump was running. It is still working after almost 3 years. Coincidentally my sealed battery vibration activated one was found dead yesterday at 2 years and 1 month past the purchase date...

I have been filling two 30 minute and three 45 min SCBA tanks all the way to 4500 psi for over a year now and my CS4 is running as well as the day I put it into service with nothing more than the required grease knob turning when the hours are reached. I have a large "orange" secondary water...

Thanks for both of the tips guys!

I was going to get rid of my 22 Jet but decided to keep it. Are there any high capacity mags made for it? My son lost one of the two mags I had for it and would prefer higher round count. Also is $15 the best price going for a factory one in 22 cal?

My mags from Carm / Darko work flawlessly. I get the right side inserting version so I can use a side focus wheel. My factory mags with the metal shim fix are also jam proof, but definitely not as smooth as the Carm mags.

My fix only solves the 2nd pellet being dragged back out of the magazine. Sorry I didn't make that more clear. I have never had any failures to feed going in, but lots of jams caused by pellets being pulled backwards.

Congrats! What scope were you using?