Recent content by Gear_Junkie

Sounds like a super fun match, I’m bummed I missed it

I’d be curious about this too.

Thanks to everyone for all of the experiences and ideas, I really appreciate it!

Great idea - I think playing with harmonics might be my next step in improving things. I have tried several different moderators (including no moderator), and I didn't notice any differences... but then again they are all pretty close in weight. I have a couple Limbsaver Barrel Deresonators...

Definitely solid advice! I did try numerous projectiles, reg pressures, and light and heavy hammers to try and get the rig as efficient as possible. I then went slightly up and down in energy with the best projectiles to figure out the sweet spot. Like someone below mentioned... I think maybe...

Your setup is the one that I copied 😁 . I bought the top pad and bottom pads that you recommended, but I cheaped out a bit and got a lower cost lift. This setup definitely help with consistency.

I've been shooting my 22cal RAW quite a bit the past six months. I've found a couple really good pellet/speed combos, shooting 25.4gr Rangemasters at 805fps or Monster Lights at 885fps. It's shooting around 35fpe. More power than this would cause the gun to jump a bit. I've also found what...

Thanks! Any idea when smaller calibers will be available?

These look nice. I appreciate that the core is machined aluminum and not 3d printed. I would not buy one without know the following details though: What is the Length? What is the O.D.? Also, cores built for smaller caliber would be great!

Beautiful rifle, and congrats on the tune!

nice! nice!

Are the outside edges of the volumax wider than the bottle? Just curious... Thanks

Mental note - avoid Bushnell scopes (n)

Unfortunately, I bought it about 9 years ago :p. Maybe they will still have a few around... Good luck!

I bought it direct from Diana. It was only around a couple hundred dollars IIRC.