Recent content by garymck

Thanks for the suggestion, I have a Dremel and polishing kit so I will give this a try... cheers Gary

Hi, I removed the action from the stock and adjusted the screw that adjusts the sear engagement - loosened it until it wouldn't cock, then tightened it until it would just cock again. I did not adjust the spring that I think does the first stage. cheers Gary

Hi, I am new to shooting and purchased a .22 Kral Puncher Breaker. I've only put about 150 shots through it but have been very please with its accuracy, (have managed groups 2 .pellet widths wide a few times at 20 meters) though not to please with my inconsistency :-) One of things I've bound...

Thanks for the pics...I'll have to see if I can make a butt plate like that. Also want to see what I can do to lighten the trigger more - will checkout the JSAR sear... cheers Gary Geelong Australia

Well, second night shooting with the Puncher breaker......Rotating the mounts for the scope and shimming the scope cured the inability to align scope to gun. I also lightened the trigger as far as is safe and tried to shoot some groups at 20 metres. Dang this shooting is HARD, the best I managed...

Thanks! Will do, also thanks for the link re trigger adjustment...... cheers Gary Geelong Australia

The barrel is bare - even shrouded would only be decorative as any form of quieting is illegal here. !0 metres is close, but I would like to have that option as I will often be shooting indoors....outside the max range will generally be 50 metres....However it will be a while before I get...

Hi, had my first shots with my new Puncher Breaker.. Had given the barrel a good clean (very little grunge came out so barrel was nowhere near as oily as I had expected based on other reports). Trooped off to the local target club and proceeded to do an initial sighting in of scope at 10...

Ian, the Dreamlines will not be in stock for another week or two - I enquired last Monday. They are apparently in customs awaiting clearance. They told me are only getting the Dreamline Lite as the others are not yet available apparently. I decided on the Kral as a minimum decent entry level...

Hi Ian, I ended up buying in Geelong would you believe. I actually chased down every licensed gun dealer in Victoria and NONE of the had any decent PCP's in stock. I then found a wholesaler who stocked Krals (amongst others), after enquiring, he was prepared to sell to me direct because there...

MScottLeeman, Can you give me some detail on exactly what you did to - "Ported valve/enlarged air transfer through to the barrel" - sizes you enlarged oetc? I'd like to do this fairly soon, and will also polish the components you mentioned. Will just have a week or two shooting before I...

Hi all, Picked up the PB an hour ago. Ended up liking the all black version better than the marine (I intend to later hydro dip the stock and thought that the black barrel would look better) Pick attached - the same as any other PB, but it's mine :-) cheers Gary Geelong Australia

Sam, have decided on .22 like you and hoping to get the PB today if possible - will post pic if I do manage to get it. Sorry to hear about your shoulder and hope you can get some relief, hopefully without surgery. In my case getting old (I'm 67) sucks, right hip replacement and bypass...

Kayaker, I only wish we in Australia could pay the prices that you do! A Puncher Breaker here is $AU900..... I will also end up doing a pile of mods like yourself. Mike, have emailed Annihilator Airguns before, but like others got no reply. cheers Gary Geelong, Australia 

Thanks so much for your reply. With low end PCP's so thin on the ground in Australia, and the old reports re Puncher Breakers, I was a little hesitant. I was worried that I would have to spend more than double the Puncher Breaker's price to get something decent. As I'm retired, I would have had...