Gambler's latest activity

Please share your website

Yeah, if the o ring fails i just take it out and buy a slug probe, its on the shopping list together with a 700mm air cylinder anyway...

Yeah i was thinking of take abit off from the probe, i also tought about opening up the liner abit but was unsure of how it will seal...

The probe hits the liner is whats the problem, I dont know if there is any adjustments to the probe so I can dial it back 2mm? Cuz the...

Ill take it all apart tomorrow and see what I can find

Its normal to cock after I get over the "bump". And it was not like this before I moved the barrel assembley where it supposed to stay...

I dont think anything is stuck cuz I can put in a slug and push it in with a ziptie the same depth as the probe should do. It shoots...

Dont know if the vid makes justice enough for how hard it is

I did not clean anything, just loosend the 3 grup screws and pushed the barrel assembly in all the way where it supposed to be. I did...

Nah, I can put in a mag and shoot normalt, except for the hard "final stage" og the lever

Hi. When I was shooting my drs today i noticed that my barrel had moved 1-2mm forward (the brass that sticks out to guide magazine was...

Do they have a webshop? :)

I dont think the angle has anything to do with it since the inlet port is also angled to match the valve. But when I upgraded my .177 to...

On my drs the fps stoped at around 120-125bar with stock 10g hammer, I bought a huma tungsten (24g) and grinded it down to 18g and that...

Yeah ive seen it, but 700 are still in presale :/