Recent content by FXmaster

Yes, the gold one kinda looks familiar. That was one of a kind that Donny FL wanted me to tune. Here more photo of the gold one.

I agree with post number two and three! I'm assuming not too many sold so not too many gonna be resold

No, sold 2 years ago and sold in 1 day, and even had multiple offers. Maybe just because it was customized by me, has a gauge on the extended Plenum full lenght CF shroud and has a 600mm .22 FX STX barrel

Nice collection, here's some of mine back in 2017

Thanks man, at 900fps the barrel, vibrates a lot up and down so I installed a tension 6 pound bull barrel weight that help a lot just rear recoil now and I hope that helps on accuracy. I'm pretty sure it would😁

Man about time, I made one 2 years ago and showed to FX of Sweden. 1/2 20 barrel threads just past the barrel clamp. Setup to shoot the .22 hybrids at 900 ft./s

I seen spring #68 being shorter then the norm so its weaker to prevent the wheel from accidental movement and not moving while cocking the hammer spring. Quick fix put a shim in different thickness to strengthen the spring and see if it helps.

Going to test the M4 impact with the Hyper bloc 100 rear block with internal 45cc plenum, and test the AEA .357 110gn plellet and see if accurate enough over 900fps or whatever speed is accurate and then see how much drift this heavy pallet shows in calm and windy condition and decide if...

Moderator causes turbulence in all baffle internal design or how tight the muzzle exit hole is, if you change moderator or remove , all of them will have a different / slight point of impact shift. Also, if you add a moderator, the baffles tightness will help propel the projectile that...

Yes, its a standard twist rate. I found crossman premier 10.5 grain brown box to be the most accurate pallet on my 700mm .177 liner.

It's nice to watch multiple video on the issue to have a better outlook in the way to look for the leak. If you have 10 bars, pressure drop daily most likely is a leak not a temperature change. If getting charged $400 to repair a leak I'm willing to help you out to fix that leak. All I ask is...

Hi Enkey, can u confirm the location of the small leak? There about 5 orings in the powerblock. The most commend is the valve seat oring not sealing against the valve housing due to poor machining, the bore for the valve seat is loose. The bore is over enlarged, the delrine seal on the valve...

Thanks that really means a lot to me

Wow didn't look at the date, been gone a long time website format is something to get use too. Thanks REVOMAN

torque requirement on m3 cap screws: https://www.melco-service.com/docs/AMAYA_OS_v10/AMAYA/Torque_Specifications.htm