Recent content by fusion

I use a Patchworm cleaning kit, and I found I had to use 2 patches to get enough compression to remove lead in my HW97. It's difficult to pull through, but it does work.

My rifle became much quieter with the new spring. It was frustrating before because every shot you could hear a ton of wasted air. Now I think it’s perfect.

I didn't adjust the regulator before I changed the spring. When I bought the rifle from a forum member, the factor regulator wasn't working, so I replaced it with a Huma regulator. I adjusted the hammer spring to achieve 880 fps with JSB 15.9 pellets and saw about 32 shots in the regulator. I...

I tried to post pictures of the new and old spring data, but it’s giving me a server error.

Hello All, I had a big win with a new spring on my BSA R10 SE in .22. The stock setup was getting about 32 shots on the regulator., and I didn't think this was enough, so I started looking at adding a SSG. I had seen some designs of SSG that would work, but they required cutting a hole in the...

jlharden, where did you get that stock. It's beautiful. Mike

Charlie, where did you get your larger tank? Does it fit well with the forend shape? I was afraid there would be a large gap and it wouldn't look right. Thanks! Mike

Here’s a little IDPA target. The A zone is .25x.5”.

I think the erratic velocity shown in that article could be caused by a faulty regulator. I saw very inconsistent velocities in my R10 and replaced the regulator with one made by Huma. It has been very consistent since then. I didn't take the time to really tune it for shot count though. I...

My R10 Mk2 is about 860 fps and gets 40 shots per fill.

Amazing craftsmanship!!

Yong Heng pump. 5 years old. No problems yet, just change oil. I use it 2 times per month, 10 minutes per fill on a SCBA tank 2900-4200 psi. I think it was about $280.

My R10 was very erratic with the factory regulator. It's been very consistent once I installed a Huma regulator.

That front cap on the muzzle weight has a hex form on the central hole. Use a metric hex wrench to remove it, then you will be able to have access to the felt pellet you push through. I use a patch worm brand cleaning tool on mine.

I've used Vortek kits in all my springers and have been very happy with the results. Mike