Recent content by Floridaman2005

Iguana hunter here. I switched to the 25.39g Hades Monsters and they are devastating against the iguanas. I sling them 880 fps and they are ridiculously powerful. At 880 fps they hit about 43 FPE and obliterate their skulls.

Impact M3 500mm .22 25.39g Hades Monsters 135 front reg / 115 rear reg 3.75 hammer 3.5 lines on valve adjuster With these settings I'm slinging the 25.39g Hades Monsters at 880, zerod from 25-45 yards. I used mine for iguana control/hunting and it's very accurate and consistent.

No I have not. I didn’t want to do the moderator swap on it. It’s kind of a hack job (literally) to get it on the Notos, and I am kind of against dumping money into the Notos. Why buy the cheapest gun on the market and then spend a ton of money modifying it when you can just get a better gun...

A good way to think about this is how many miles per gallon cars get. What determines miles per gallon? Weight, aerodynamics, speed, fuel capacity, blah blah blah, you get the picture. Set your cruise control on 60 mph and then set your cruise control on 80 mph. It will be significantly less...

I got mine from Firewalker as well but the one I linked is essentially the same. It’s definitely effective, but still not as quiet as a DonnyFL.

Where did you get the part? Through him directly? Or is there a link somewhere?

They are both still bad methods. 1, you don’t go full hammer off the rip and find target velocity and close valve til speed drops. That’s not how tuning works. Using that method you would be over hammering the snot out of the gun, and then try to adjust for that by closing the valve? There’s...

You are a weird dude. Nobody can understand what you are asking. You asked the pros and cons of tuning 2 different ways. One of which isn’t even a way to tune at all…you have no idea what to ask and how to ask it. That’s the real problem.

You are the one looking for advise. I’d say the same to you. I don’t know why I’m even trying anymore but WHAT CALIBER AND LENGTH IS YOUR M4 AND WHAT AMMO ARE YOU SHOOTING???

There must be some sort of language barrier that’s preventing you from fully understanding. What I’m describing to you and what the video from Utah Airgun’s shows is not starting with the hammer cranked all the way up you start with a low hammer and slowly work your way up until you reach peak...

Does it matter if you get optimal velocity? I again don’t know what you are asking. Why would you want anything other than optimal velocity? I tuned my gun to shoot the pellets I want to shoot at the speeds I want to shoot. How else are you coming up with your “tune”? My gun shoots my pellets...

Absolutely true. Shooting 860 fps at 80/120 reg pressures. Get a fork and a knife so you can have a nice big plate of that 🐂 💩 Have you never seen AEAC’s video on Impact tuning? Or his tuning charts? I normally wouldn’t even respond to people like you who are only here to be dicks, but it’s...

You can get tight groups using either option, but that doesn’t mean the gun will be accurate at all distances. You still haven’t mentioned what caliber your gun is and what your barrel length is. Do you have a chronograph? Do you know exactly what speed your gun is shooting at? If you don’t...

Yeah man, the 2nd video from Utah Airguns does a good job explaining things. Follow that. That’s essentially what I already told you, but that’s a good starting point

It absolutely matters and once again. Start with the basics. What caliber is your gun. What length barrel. At minimum you must give that information because that will determine what pressure to set your regulator. What weight ammo are you shooting. Pellets or slugs? Again, what is your goal...