fishing43's latest activity
In the stock there is a rubber pad in the area of the sling mounting post. One bolt holding the receiver to the stock. Torqued it to...- fishing43 reacted to carlcrawford's post in the thread new to guns, need purchase recommendations with
Like. Hello, I am looking for recommendations on what to purchase for attempting to eliminate pest crows invading my farm (and yes, this is... - Years back I run into a foam making/selling company in Toronto, and I bought a 2" thick 4'x8' sheet, black closed cell foam. The price...
- I just came across a great website that sells foam cheap. And just ordered some, we'll see the quality of it, ill come in, in around 10...
- It could very well be that the foam was water absorbent. There was no evidence of any corrosion whatsoever from the trip both ways...
- The cross linked polyethylene stuff is non-absorbent, there are closed cell foams that will absorb water (polyurethane).
- I’ve done the sandwiching guns between foam pads before. It can work depending upon the quality of your case and its sealing mechanisms...
- When we were prepping to travel to Finland I got to looking for replacement foam for a couple rifle cases that had already been plucked...
- Yup, too many airguns to keep track of pressures, preferred pellets, tuning details and sighting in information. I keep a file for each...
- fishing43 reacted to thomasair's post in the thread FX Tuning to the knee… or maybe not?! with Like. The only way I have found to stay way below the knee is with a super heavy hammer. You can hold a 10fps spread at 8-10% below the...
- fishing43 reacted to RoosterCogburn's post in the thread FX Tuning to the knee… or maybe not?! with Like. I appreciate it. I think my obsessive and meticulous perfectionist nature coupled with the inherent neuroticism of being a sperg plays...
- fishing43 reacted to Hollow legs's post in the thread Taipan 25 Caliber Taipan Vet 2 Standard with Like. Hi all you Taipan Veteran owners, I am now the proud owner of one, full power. I have not actually used it yet for various reasons but...
- Engineer? Ok this should be easy for you. Program an arduino to work with an Fx chrony so that it calls out your shots from a tiny speaker.
- I just keep track by looking at the left side of the mag. You can see the last few pellets making their way towards the breech. When I...
- fishing43 reacted to SMH's post in the thread AirMaks Arms Can a 280mm barrel be accurate? with Like. Not sure about all of them, but if it’s a Cz barrel and attached to a Airmaks Katran CB, it definitely can. This rifle is sighted in...