Recent content by Fac

Hp2

Yes that's him he has modified them now he sent me the older one but these are fine

There a feller on ebay will 3d print a mag what will take up to a 30.5 zan iv been using 28grn 217 and 25 grn 218 both work well reg on 135 bar

I'm shooting 25grn 218s they doing good

H&N 25 grn 218s slugs 970fps reg on about 122 ish

What's the heaviest weight slug have krait uses had through there 22 mag I use 25grn iv seen vids of people using 30grn but I cannot get 30grn to fit there to long?

There a new pard coming out soon a new 008

Iv had 2 different Valve rods in it the one what was in were oring is was 3.64 mil and bought a new one which was 3.76 mil from shop and wudnt go into hole at block so took a bit off till it went in very fine tollerences thanks for reply

Thanks for reply wm iv tryed everything I can with gun I bought it second hand and everything the owner put on it aftermarket iv changed I.e the huma dual transfer port pin probe iv changed new valve and valve seat even changed the hole block and its not as bad now but still getting odd blow...

Hi this is my first post from UK lads and lasses I have a mk3 wildcat sniper 700 in 22 and I keep getting a puff of air through hole in block in front of reg gauge I seen a vid on the tube and it said it was small 1x1 1/2 oring on valve iv changed it a few time but after a few shots it starts...