Recent content by DrSeagram

Could've been worse, he could've chose Sportsman Gun Centre as his importers 😆

It's not my job as the end consumer to have to strip, modify & put right a gun that is brand new & purchased as FAC (full power). This is not how the experience should be, tuning yes i totally understand that. But not hours, days, weeks of time & money trying to figure out why a new gun isn't...

Is that part of the dwell valve? Here's mine, not quiet sure what that part is? Is it the transfer port, if so how did you get to it?

I've tried over 4 brands & 8 different weights of slugs, I think thats enough, definitely enough on my wallet

The new Mora's don't have a hammer spring, the hammer now works on a pneumatic system. So you no longer adjust the hammer in the rear of the butt pad with an Allan key. It now self adjusts according to reg pressure. This cannot be retro fitted to the earlier Moras. The gauge for the regulator...

I own a RTI P3 performance, which is an amazing gun, incredibly easy to tune & accurate, so when all the hype about the Mora first started I already knew that was going to be my next purchase, a 700mm in .25 calibre. The first Mora I received had a badly etched serial number, so I couldn't put...

I'm running my Krait X at 980fps, reg at 160, using the H&N HP2's 30gr .217. These are very good, my longest shot, see the attached video, was 148y. I use the single shot loader, I find it gives better accuracy, you can also fit the H&N HP2's 34gr in the single shot loader but the max fps...

I hope your recovering well from your stroke, keep me updated on the progress with your Krait 😊 P.S. I did polish my barrel with bore paste.

How was accuracy? I'd definitely give the H&N HP2 30rg a go. They were amazing & devastating when they hit.

What or how are you modifying the hammer? Are you sure it's not the actual hammer spring holding you back?? A good replacement hammer spring can be made by purchasing these &cutting them to size. There practically identical dimensions, but higher quality than the stock springs. sourcing map 3D...

I did bore scope mine on arrival. It was very well machined, with no visibile imperfections. After much lead, air & time if found the H&H HP2 30gn .217 are amazing. My longest shot was a bunny at 148y, reg is set at 160 & my speed is 960fps. I've attached the video of the 148y shot.

A new Krait X HP owner here, having previously owned the compact Krait, which was impressive. But im struggling to get the X to group at 50 yards? So far I've only tried Zan 28grn .218 at about 975fps & H&N 30grn .218 at around 960fps.......which seems about the max limit on this gun. Reg at 150...

Thanks for getting back to me, I'll try installing them at tge weekend 👍🏼

I'm just about to install the Huma hammer, (same as yours) & the pin probe......but im a little hesitant in regards to the pin probe. As I also plan to still occasionally use pellets as well as the FX Hybrids. So I question if the pin probe wouldn't seat the pellets deep enough past the...

Any news on the pin probe????