Recent content by droyd

It's most likely an o-ring that needs replacing or has shifted. Get some silicon grease or lube before you start tearing it down. Sub12 Airgunner has a wonderful teardown (AGT Vulcan 3 Full strip down and regulator testing) on the Vulcan 3, highly suggest looking up his video. As for it...

Hell yeah, I've gotta get some heavier slugs for my .25 Mora. That's a crazy good group

Bug Buster is way overrated imo. Get an LPVO scope or something for cheaper and better glass. Better yet, spending the same - time of writing bug buster is on 'sale' for $190, original $200 - you can get a Discovery Optics ED-AR 1-8X24 LPVO with parallax adjustment and first focal plane and a...

50mm

You'll need to show us what you're pushing on. There should be two things inside the shroud, some spacer more towards the middle of it and the baffle system at the very end of it.

My first thought is the barrel isn't pushed in all the way but my barrel has a very small gap like yours. I think mine* might be smaller. Does the magazine click into place fine? Is your barrel supported by a barrel band and if so, is that secured to the stock?

Thanks! I have full confidence in them, Brok was amazing with my last problem.

Hey guys, just a little update on my experience with the RTI Mora. It's been great so far, except for this bit. Seems that the screws I got sent with that secure the M-Lok Shield to the gun might be a little shallow. The hole is about 7.3mm deep but the screws only go about 3.2mm in depth...

Make sure the barrel is seated and the set screws are installed and snug. I set mine to 15in/lbs. Grab a bunch of rubber bands and wrap them around the shroud. This should give you the grip needed to get the shroud off. Mine was also on super-duper tight. It does need to be turned...

You'll need to depressurize and take the stock off first before taking out the regulator. Other than that, Air Venturi has some guides on the rifle on youtube but for the regulator it's just unscrewing a black screw that will keep the regulator from being fully unscrewed when adjusting, then...

I also own an avenge-x and had this same issue with my .22. It was accurate and then after a thousand or so shots the groups widened and were moving everywhere. Here's what fixed it for me: Try depressurizing and take out the regulator. Be sure to take a pic of the regulator's washers and note...

If anyone is wanting to print this themselves, here is a link to the STL file: https://www.printables.com/model/1006229-rti-mora-cheek-rest-5mm

It's pretty quiet without the moderator, supremely quiet with.

Oh. Well, yeah never mind thanks for letting me know about the carbon fibers thing. Guess I'll be skipping the carbon fiber stuff. I'm sure it's harmless, it is carbon after all, but I don't need that being embedded into my face. I'll probably go with white PLA or making this design with PCTG...