drdirk's latest activity

My talon p would also be the last to get rid off. But I do enjoy my other guns more. If somehow it was down to one that’s the one.

My advise is to start with one of the higher rated lower end guns. That is what I did. 10+ years ago I started with a Marauder and a...

I travel a lot and when you can not take your powder burner, I just recently bought a Talon P. Maybe does not quite fit the "survival"...

My first PCP was a airforce Talon over 10+ years ago. Gave to a friend when we moved. Just bought a new Talon P and the spin lock wrench...

Welcome back, I was in the same boat, many years ago, more than a decade probably I had a Marauder. Then sold it and only kept my...

I didn't, started it first to see if there is something specific about the rear mount. Then after put a note on the Owners Thread to see...

update: i pulled the scope and measured both front a back sections of the picatinny rails. I measured in several sections along both...

Thanks. It sure looks like mine is just defective from factory. I sent It to AOA today.

I’ll pull the scope off my buddy’s BW this weekend and measure. AOA is great and Daystate has a 5 year warranty so whatever the issue is...

mine are narrower than. Especially the rear. Thanks for measuring.

The width should be the same. Most rings now fit both by using the narrower crossbar.

That shouldn’t be. I can not think of a valid reason to manufacture a rail narrower than the spec. since my mount was supposed to be...

I used Monstrum pro, Barrett rings from my 50 cal powder burner and 2 short picatinny rings I had as spares that do not have a...

Good evening everyone, I just posted on a separate thread about my Blackwolf rear scope mount being loose. First I thought it is a...

Update to my post above, I measured with width of the front and rear rail section and they do NOT appear to be the same. The...